[March-2018-New]Braindump2go 300-165 PDF and VCE Free Download[105-115]

2018 March New Cisco 300-165 Exam Dumps with PDF and VCE Free Updated Today! Following are some new 300-165 Real Exam Questions:

1.|2018 Latest 300-165 Exam Dumps (PDF & VCE) 214Q&As Download:
https://www.braindump2go.com/300-165.html

2.|2018 Latest 300-165 Exam Questions & Answers Download:
https://drive.google.com/drive/folders/0B75b5xYLjSSNRU9xWGk1cFJiaTg?usp=sharing

QUESTION 105
How does addition of bandwidth between spine and leaf switches in a FabricPath architecture get utilized?

A. Links between the same set of switches are automatically added to a port channel.
B. Adding additional bandwidth is handled dynamically using the 802.1AX protocol.
C. Traffic is load shared automatically across the available paths to the destination.
D. FabricPath uses hardware bonding of physical interfaces to form higher-speed links.

Answer: C

QUESTION 106
Which two advantages does FabricPath have over Spanning Tree in implementing a loop-free network topology design? (Choose two.)

A. Blocked links can be brought in to service if active links fail.
B. Convergence times are faster.
C. Multipath forwarding is supported for unicast and multicast Layer 2 and Layer 3 traffic.
D. Unknown unicast addresses are flooded in through the originating port.

Answer: BC

QUESTION 107
Which four statements about reserved VLANs in Cisco NX-OS are true? (Choose four.)

A. The range of reserved VLANs cannot be changed.
B. The number of reserved VLANs is 96.
C. A change to the range of reserved VLANs can be performed only in the VDC default.
D. A write-erase procedure restores the default reserved VLAN range.
E. The number of reserved VLANs is 128.
F. A reload is needed for changes to take place.
G. The configuration must be saved for changes to take place.

Answer: CEFG

QUESTION 108
Which two RFCs are supported by Cisco NX-OS devices for OSPFv2? (Choose two.)

A. RFC 2238
B. RFC 1918
C. RFC 1583
D. RFC 2453
E. RFC 2740

Answer: AC

QUESTION 109
Which action limits the maximum number of routes that are allowed in the routing table?

A. Use a filter BGP.
B. Use only static routes.
C. Use the maximum routes command inside address family.
D. Use a route map to filter routes.

Answer: C

QUESTION 110
Which three options of encryption are supported in PIM hello messages? (Choose three.)

A. cleartext
B. DES-SHA1
C. DES-CBC3-SHA
D. Cisco Type 7
E. RC4-SHA
F. 3DES

Answer: ADF

QUESTION 111
Which command is used to associate EID-to-RLOC for a LISP site?

A. #feature lisp
B. #ipv6 lisp itr
C. #ip lisp database-mapping
D. #ip lisp itr map-resolver

Answer: C

QUESTION 112
In OTV, how are the VLANs split when a site has two edge devices?

A. They are configured manually by user.
B. They are split in half among each edge device.
C. They are split as odd and even VLAN IDs on each edge device.
D. It is not possible to have two edge devices in same site.

Answer: C

QUESTION 113
Which statement about the MPLS feature set is true?

A. It is not license dependent.
B. It can be installed from any VDC.
C. It can be enabled only in the default VDC.
D. It must be installed from the default VDC.

Answer: D

QUESTION 114
Refer to the exhibit. What is the maximum IPv6 unicast route memory allocated?

A. 4 MB
B. 8 MB
C. 1024 MB
D. 1 GB
E. 5 MB

Answer: A

QUESTION 115
When creating a VDC on a Cisco Nexus 7000 switch, which command in the VDC designates that only 10 port channels can be created in that VDC?

A. allocate resource port-channel 10
B. limit-resource port-channel minimum 0 maximum 10
C. allow-resource port-channel maximum 10
D. port-channel maximum 10

Answer: B

1.|2018 Latest 300-165 Exam Dumps (PDF & VCE) 214Q&As Download:
https://www.braindump2go.com/300-165.html

2.|2018 Latest 300-165 Study Guide Video:

1. http://www.youtube.com/watch?v=DCl4Vh2Wt0k
2. http://www.youtube.com/watch?v=DCl4Vh2Wt0k