This page was exported from Braindump2go Free Exam Dumps with PDF and VCE Collection [ https://www.mcitpdump.com ] Export date:Wed Dec 25 7:17:20 2024 / +0000 GMT ___________________________________________________ Title: [June-2022]300-410 VCE and PDF 300-410 406Q Instant Download in Braindump2go[Q351-Q386] --------------------------------------------------- June/2022 Latest Braindump2go 300-410 Exam Dumps with PDF and VCE Free Updated Today! Following are some new 300-410 Real Exam Questions!QUESTION 351Refer to the exhibit. TCP traffic should be reaching host 10.10.10.10/24 via R2.Which action resolves the issue? A. TCP traffic will reach the destination via R2 without any changesB. Add a permit 20 statement in the route map to allow TCP trafficC. Allow TCP in the access list with no changes to the route mapD. Set IP next-hop to 10.10.12.2 under the route-map permit 10 to allow TCP traffic.Answer: CQUESTION 352A network administrator must optimize the segment size of the TCP packet on the DMVPN IPsec protected tunnel interface, which carries application traffic from the head office to a designated branch. The TCP segment size must not overwhelm the MTU of the outbound link.Which configuration must be applied to the router to improve the application performance? A. Option AB. Option BC. Option CD. Option DAnswer: CQUESTION 353Refer to the exhibit. After configuring OSPF in R1, some external destinations in the network became unreachable. Which action resolves the issue? A. Clear the OSPF process on R1 to flush stale LSAs sent by other routers.B. Change the R1 router ID from 10.255.255.1 to a unique value and clear the process.C. Increase the SPF delay interval on R1 to synchronize routes.D. Disconnect the router with the OSPF router ID 0.0.0.0 from the network.Answer: BQUESTION 354What is the function of BFD?A. It provides uniform failure detection regardless of media type.B. It creates high CPU utilization on hardware deployments.C. It negotiates to the highest version if the neighbor version differs.D. It provides uniform failure detection on the same media type.Answer: AQUESTION 355Refer to the exhibit.A network engineer must establish communication between three different customer sites with these requirements:Site-A: must be restricted to access to any users at Site-B or Site-C.Site-B and Site-C must be able to communicate between sites and share routes using OSPF. Which configuration meets the requirements?A. Option AB. Option BC. Option CD. Option DAnswer: CQUESTION 356Refer to the exhibit. Site1 must perform unequal cost load balancing toward the segments behind Site2 and Site3. Some of the routes are getting load balanced but others are not. Which configuration allows Site1 to load balance toward all the LAN segments of the remote routers? A. Option AB. Option BC. Option CD. Option DAnswer: DQUESTION 357Refer to the exhibit. An engineer implemented an access list on R1 to allow anyone to Telnet except R2 Loopback0 to R1 Loopback4.How must sequence 20 be replaced on the R1 access list to resolve the issue? A. Option AB. Option BC. Option CD. Option DAnswer: CQUESTION 358An engineer notices that R1 does not hold enough log messages to Identity the root cause during troubleshooting.Which command resolves this issue? A. Option AB. Option BC. Option CD. Option DAnswer: BQUESTION 359Refer to the Exhibit. R1 and R2 use IGP protocol to route traffic between AS 100 and AS 200 despite being configured to use BGP. Which action resolves the issue and ensures the use of BGP? A. Configure distance to 100 under the EIGRP process of R1 and R2.B. Remove distance commands under BGP AS 100 and AS 200.C. Remove distance commands under BGP AS 100.D. Configure distance to 100 under the OSPF process of R1 and R2Answer: BQUESTION 360Refer to the exhibit. An engineer is trying to connect to R1 via Telnet with no success.Which configuration resolves the issue? A. Option AB. Option BC. Option CD. Option DAnswer: BQUESTION 361Refer to the exhibit. An engineer must configure PBR on R1 to reach to 10.2.2.0/24 via R3 AS64513 as the primary path and a backup route through default route via R2 AS64513. All BGP routes are in the routing table of R1, but a static default route overrides BGP routes. Which PBR configuration achieves the objective? A. Option AB. Option BC. Option CD. Option DAnswer: BQUESTION 362Refer to the exhibit. An administrator configured a Cisco router for TACACS authentication, but the router is using the local enable password instead. Which action resolves the issue? A. Option AB. Option BC. Option CD. Option DAnswer: CQUESTION 363Refer to the exhibit. An engineer configured BGP and wants to select the path from 10.77.255.57 as the best path instead of current best path. Which action resolves the issue? A. Configure AS_PATH prepend for the desired best pathB. Configure higher MED to select as the best path.C. Configure lower LOCAL_PREF to select as the best path.D. Configure AS_PATH prepend for the current best pathAnswer: DQUESTION 364What is LDP label binding?A. neighboring router with labelB. source prefix with labelC. destination prefix with labelD. two routers with label distribution sessionAnswer: CQUESTION 365Which table is used to map the packets in an MPLS LSP that exit from the same interface, via the same next hop, and have the same queuing policies?A. RIBB. FECC. LDPD. CEFAnswer: BQUESTION 366Refer to the exhibit. The IT router has been configured with the Science VRF and the interfaces have been assigned to the VRF.Which set of configurations advertises Science-1 and Science-2 routes using EIGRPAS 111? A. Option AB. Option BC. Option CD. Option DAnswer: DQUESTION 367Refer to the exhibit. When an FTP client attempts to use passive FTP to connect to the FTP server, the file transfers fail Which action resolves the issue? A. Configure active FTP traffic.B. Modify FTP-SERVER access list to remove established at the end.C. Modify traffic filter FTP-SERVER in to the outbound direction.D. Configure to permit TCP ports higher than 1023.Answer: DQUESTION 368In a DMVPN network, the Spoke1 user observed that the voice traffic is coming to Spoke2 users via the hub router. Which command is required on both spoke routers to communicate directly to one another?A. ip nhrp map dynamicB. ip nhrp shortcutC. ip nhrp nhs multicastD. ip nhrp redirectAnswer: BQUESTION 369Refer to the exhibit. The network administrator configured the network to establish connectivity between all devices and notices that the ASBRs do not have routes for each other. Which set of configurations resolves this issue? A. Option AB. Option BC. Option CD. Option DAnswer: DQUESTION 370Refer to the exhibit. The network administrator configured the Chicago router to mutually redistribute the LA and NewYork routes with OSPF routes to be summarized as a single route in EIGRP using the longest summary mask: After the configuration, the New York router receives all the specific LA routes but the summary route. Which set of configurations resolves the issue on the Chicago router? A. Option AB. Option BC. Option CD. Option DAnswer: BQUESTION 371Refer to the exhibit. An engineer must configure DMVPN Phase 3 hub-and-spoke topology to enable a spoke-to-spoke tunnel. Which NHRP configuration meets the requirement on R6? A. Option AB. Option BC. Option CD. Option DAnswer: BQUESTION 372Refer to the exhibit. An engineer implemented CoPP to limit Telnet traffic to protect the router CPU. It was noticed that the Telnet traffic did not pass through CoPP.Which configuration resolves the issue? A. Option AB. Option BC. Option CD. Option DAnswer: DQUESTION 373Refer to the exhibit. An engineer implemented CoPP but did not see OSPF traffic going through it. Which configuration resolves the issue? A. Option AB. Option BC. Option CD. Option DAnswer: BQUESTION 374An engineer must override the normal routing behavior of a router for Telnet traffic that is destined to 10.10.10.10 from 10.10.1.0/24 via a next hop of 10.4.4.4 which is directly connected to the router that is connected to the 10.1.1.0/24 subnet.Which configuration reroutes traffic according to this requirement? A. Option AB. Option BC. Option CD. Option DAnswer: BQUESTION 375Refer to the exhibit. An engineer must redistribute networks 192.168.10.0/24 and 192.168.20.0/24 into OSPF from EIGRP. Where the metric must be added when traversing through multiple hops to start an external route of 20. The engineer notices that the external metric is fixed and does not add at each hop. Which configuration resolves the issue? A. Option AB. Option BC. Option CD. Option DAnswer: BQUESTION 376An administrator attempts to download the pack NBAR2 file using TFTP from the CPE router to another device over the Gi0/0 interface. The CPE is configured as below: The transfer fails. Which action resolves the issue?A. Change the WAN ACL to permit the UDP port 69 to allow TFTPB. Make the permit udp any eq tftp any entry the last entry in the WAN ACL.C. Change the WAN ACL to permit the entire UDP destination port rangeD. Shorten the file name to the 8+3 naming convention.Answer: BQUESTION 377What is an MPLS LDP targeted session?A. session between neighbors that are connected no more than one hop awayB. LDP session established between LSRs by exchanging TCP hello packetsC. label distribution session between non-directly connected neighborsD. LDP session established by exchanging multicast hello packetsAnswer: CQUESTION 378Refer to the exhibit. An administrator configures a router to stop using a particular default route if the DNS server 8.8.8.8 is not reachable through that route. However, this configuration did not work as desired and the default route still works even if the DNS server 8.8.8 8 is unreachable. Which two configuration changes resolve the issue? (Choose two.) A. Configure two static routes for the 8.8.8.8/32 destination to match the IP SLA probe for each ISP.B. Associate every IP SLA probe with the proper WAN address of the router.C. Reference the proper exit interfaces along with the next hops in both static default routes.D. Use a separate track object to reference the existing IP SLA 1 probe for every static route.E. Use a separate IP SLA probe and track object for every static routeAnswer: AEQUESTION 379Refer to the exhibit. A network administrator must block ping from user 3 to the App Server only. An inbound standard access list is applied to R1 interface G0/0 to block ping. The network administrator was notified that user 3 cannot even ping user 9 anymore.Where must the access list be applied in the outgoing direction to resolve the issue? A. R2 interface G1/0B. R2 interface GO/0C. SW1 interface G1/10D. SW1 interface G2/21Answer: DQUESTION 380Refer to the exhibit. Refer to the exhibit. A network engineer receives a report that Spoke 1 users can perform bank transactions with the server located at the Center site, but Spoke 2 users cannot. Which action resolves the issue? A. Configure the Spoke 2 users IP on the router B OSPF domainB. Configure encapsulation dot1q 78 on the router C interface.C. Configure IPv6 on the routers B and C interfacesD. Configure OSPFv2 on the routers B and C interfacesAnswer: CQUESTION 381Refer to the exhibit. An engineer configured route exchange between two different companies for a migration project EIGRP routes were learned in router C but no OSPF routes were learned in routerA. Which configuration allows router A to receive OSPF routes? A. Option AB. Option BC. Option CD. Option DAnswer: BQUESTION 382A network administrator cannot connect to a device via SSH. The line vty configuration is as follows: Which action resolves this issue?A. Increase the session timeoutB. Change the stopbits to 10.C. Configure the transport input SSHD. initialize the SSH keyAnswer: DQUESTION 383Refer to the exhibits. London must reach Rome using a faster path via EIGRP if all the links are up but it failed to take this path. Which action resolves the issue? A. Increase the bandwidth of the link between London and BarcelonaB. Use the network statement on London to inject the 172 16 X 0/24 networks into EIGRP.C. Change the administrative distance of RIP to 150D. Use the network statement on Rome to inject the 172 16 X 0/24 networks into EIGRPAnswer: DQUESTION 384Refer to the exhibit. The company implemented uRPF to address an antispoofing attack. A network engineer received a call from the IT security department that the regional data center is under an IP attack. Which configuration must be implemented on R1 to resolve this issue? A. Option AB. Option BC. Option CD. Option DAnswer: BQUESTION 385What is a function of BFD?A. peer recovery after a Layer 3 protocol adjacency failureB. peer recovery after a Layer 2 adjacency failureC. failure detection independent of routing protocols and media typesD. failure detection dependent on routing protocols and media typesAnswer: DQUESTION 386Refer to the exhibit. AS 111 mut not be used as a transit AS, but ISP-1 is getting ISP-2 routes from AS 111. Which configuration stops Customer AS from being used as a transit path on ISP-1? A. ip as-path access-list 1 permit ^$B. ip as-path access-list 1 permit_111_C. ip as-path access-list 1 permit."D. ip as-path access-list 1 permit ^111$Answer: AResources From:1.2022 Latest Braindump2go 300-410 Exam Dumps (PDF & VCE) Free Share:https://www.braindump2go.com/300-410.html2.2022 Latest Braindump2go 300-410 PDF and 300-410 VCE Dumps Free Share:https://drive.google.com/drive/folders/1NkZ6PH5JebhsyHrMEXD3IWxkOLRjQ-B-?usp=sharing3.2021 Free Braindump2go 300-410 Exam Questions Download:https://www.braindump2go.com/free-online-pdf/300-410-PDF-Dumps(351-386).pdfFree Resources from Braindump2go,We Devoted to Helping You 100% Pass All Exams! --------------------------------------------------- Images: --------------------------------------------------- --------------------------------------------------- Post date: 2022-06-17 08:39:10 Post date GMT: 2022-06-17 08:39:10 Post modified date: 2022-06-17 08:39:10 Post modified date GMT: 2022-06-17 08:39:10 ____________________________________________________________________________________________ Export of Post and Page as text file has been powered by [ Universal Post Manager ] plugin from www.gconverters.com