[20th/11/2017]Exam 200-105 VCE and PDF 497Q Free Offered by Braindump2go[251-261]

2017 November New 200-105 Exam Dumps with PDF and VCE Free Updated Today! Following are some new 200-105 Questions:

1.|2017 New 200-105 Exam Dumps (PDF & VCE) 497Q&As Download:
https://www.braindump2go.com/200-105.html

2.|2017 New 200-105 Exam Questions & Answers Download:
https://drive.google.com/drive/folders/0B75b5xYLjSSNeGdLM0gta2VVYm8?usp=sharing

QUESTION 251
Which two privileged mode Cisco IOS commands can be used to determine a Cisco router chassis serial number? (Choose two.)

A. show diag
B. show controllers
C. show inventory
D. show flash: filesys
E. dir flash: | include chassis

Answer: AC

QUESTION 252
Which two are features of IPv6? (Choose two.)

A. anycast
B. broadcast
C. multicast
D. podcast
E. allcast

Answer: AC

QUESTION 253
Which three are characteristics of an IPv6 anycast address? (Choose three.)

A. one-to-many communication model
B. one-to-nearest communication model
C. any-to-many communication model
D. a unique IPv6 address for each device in the group
E. the same address for multiple devices in the group
F. delivery of packets to the group interface that is closest to the sending device

Answer: BEF

QUESTION 254
Given an IP address 172.16.28.252 with a subnet mask of 255.255.240.0, what is the correct network address?

A. 172.16.16.0
B. 172.16.0.0
C. 172.16.24.0
D. 172.16.28.0

Answer: A

QUESTION 255
Which command helps a network administrator to manage memory by displaying flash memory and NVRAM utilization?

A. show version
B. show ram
C. show flash:
D. show file systems

Answer: D

QUESTION 256
Which pairing reflects a correct protocol-and-metric relationship?

A. EIGRP and link cost
B. OSPF and number of hops and reliability
C. RIPv2 and number of hops
D. IS-IS and delay and reliability

Answer: C

QUESTION 257
A network administrator needs to allow only one Telnet connection to a router. For anyone viewing the configuration and issuing the show run command, the password for Telnet access should be encrypted. Which set of commands will accomplish this task?

A. service password-encryption
access-listl permit 192.168.1.0.0.0.0.255
line vty0 4
login
password cisco
access-class 1
B. enable password secret
line vty0
login
password cisco
C. service password-encryption
line vty0
login
password cisco
D. service password-encryption
line vty0 4
login
password cisco

Answer: C

QUESTION 258
Which set of commands is recommended to prevent the use of a hub in the access layer?

A. switch(config-if)#switchport mode trunk
switch(config-if)#switchport port-security maximum 1
B. switch(config-if)#switchport mode trunk
switch(config-if)#switchport port-security mac-address 1
C. switch(config-if)#switchport mode access
switch(config-if)#switchport port-security maximum 1
D. switch(config-if)#switchport mode access
switch(config-if)#switchport port-security mac-address 1

Answer: C

QUESTION 259
Refer to the exhibit. A frame on VLAN 1 on switch S1 is sent to switch S2 where the frame is received on VLAN 2. What causes this behavior?

A. trunk mode mismatches
B. allowing only VLAN 2 on the destination
C. native VLAN mismatches
D. VLANs that do not correspond to a unique IP subnet

Answer: C

QUESTION 260
Which command reveals the last method used to powercycle a router?

A. show reload
B. show boot
C. show running-config
D. show version

Answer: D

QUESTION 261
Which two statements are characteristics of a distance vector routing protocol? (Choose two.)

A. Each router has its own view of the topology.
B. Updates are periodic and include the entire routing table.
C. Routing updates are sent only after topology changes.
D. Convergence is usually faster than with link state protocols.
E. RIP is an example of distance vector routing protocols.
F. The protocol can be useful in hub-and-spoke and hierarchical networks.

Answer: BE

2.|2017 New 200-105 Study Guide Video;

YouTube Video: YouTube.com/watch?v=cZLc8uMYA0Q